Idiomas disponibles
Idiomas disponibles
•
Do not use paints or solvents containing halogen
hydrocarbon (as methylene chloride). Thease
products can cause dangerous chemical reac-
tions running the risk of corrosion or explosion
if they are in contact with parts of the equipment
i alluminium. In any case, always check that the
product is compatibile with the materials com-
posing the equipment (pump spray gun, flexble
hose and accessories) with winich it can come
into contact.
sETTINg-UP
d
installation
•
Fix the pump on a base by using the supporting brackets
holes.
never install the pump upside-down or inclined
connection to the reed air
•
For pump feed use a hose with a internal diameter no
lower than 6 mm.
E
WoRKINg
Check all the connection fittings of
the components (pump. flexble hose,
etc.) before using the equipment.
•
Dip the suction hose into the tank of the product.
•
Let compressed air flow to the pump. Adjust air pressure
to the minimum level necessary to the working of the
pump continually
lARIUs 2 - transfer
•
If the product be used is toxic, avoid inhalation
and contact by using protectio gloves, goggles
and propor face shields.
suction and delivery hoses connection
•
Connect the suction and delivery hoses to the pump it
is suggested to tighten the fillings.
•
Make sure the hoses are not too heavy for the pump
structure
•
WashinG of the brand neW eQuipment
•
The LARIUS 2 pump has been tested at our plant with
light mineral oil left inside of the pumping elementi
ad protection. Before sucking the product, carry out a
washing using a diluent.
•
The suction hose diameter must be proper to the vi-
scosity of the fluid to be pumped. The installation of a
filer at the end of the suction hose is recommended.
•
The pump will start and sto when all the product
chamber will be full. Each time the delivery valve is
open, the pump will start again to work.
WarninG! avoid pump iding becau-
se it could damage the pneumatic
system and the membranes.
12
