Idiomas disponibles
Idiomas disponibles
Installation instructions
5. Check if the burner head/burner cap is firmly seated. If the burner head/cap is not level or is
unstable, you must take it off, and reinsert it again.
Other burner assembly:
1. Identify 13200BTU/5800BTU/3000BTU burner head and burner cap by size.
2. Hold the burner head, then find the gap "C" and ignition needle "D", make it on the same side.
C
D
3. Place the burner head with the gap "C" next to the ignition needle "D" and make sure the burner
head is firmly seated.
4. Place the lined part of burner cap to fit in the lined part of the burner head. Shake the burner
cap gently to check if it is firmly seated.
5. Check if the burner head/burner cap is firmly seated. If the burner head/cap is not level or is
unstable, you must take it off, and reinsert it again.
-15-
Install the grates
Do not try to remove the grate until the cooking grates and cooktop
WARNING
surface have completely cooled down.
1
1
Left/Right Grate(same)
The three cooktop grates are designed to fit in specific positions on the cooktop. For maximum
stability, these grates should only be used in their proper positions.
To properly setup your cooking grates, please follow these steps:
1. Take out the three grates and find the center grate first. Note, the left and right grids are exactly
the same.
2. Gently lower the legs of the center grate so they rest in the center grate dimples of the cooktop.
3. Take the other two grates and make sure the thicker sides of the grates face the outer left and
right sides of the cooktop.
4. Gently lower the legs of the grates into the dimples of the cooktop. When properly installed,
neither grate will make contact with the overhangs of the center grate.
Thicker sides
Installation instructions
1
2
2
Center Grate
Thicker sides
-16-
