Idiomas disponibles
Idiomas disponibles
First Steps
This Use & Care Guide
provides
general
installation
and operating
instructions
for your model.
We recommend
using a
service
or kitchen
contracting
professional
to install your appliance.
Use the unit only
as instructed
in this Use & Care Guide.
Before
starting
the appliance,
follow
these
important
first steps.
Location
* Choose a place
that is near a grounded,
non-GFCI,
electrical
outlet.
Do Not use an
extension
cord or an adapter
plug.
* For the most efficient
operation,
the unit
should
be located
where surrounding
temperatures
will not drop below
40°F
(5°C) or exceed
110°F (43°C).
Additional
compressor
heaters
are not recommended.
* Allow
space around
the unit for good
air circulation.
Leave a 3" (75 mm) space
on all sides of the appliance
for adequate
circulation.
3" (75 mm)
1"(25 mm)
NOTE
The exterior
walls of the appliance
may
become
quite warm
as the compressor
works to transfer
heat from the inside.
Temperatures
as much as 30°F warmer
than room temperature
can be expected.
For this reason
it is particularly
important
in hotter climates
to allow enough
space
for air circulation
around
your unit.
Leveling
The unit must have all bottom
corners resting
firmly on a solid floor. The floor
must be strong
enough to support
a fully loaded
appliance.
NOTE
it is Very
important
for your appliance
to
be level in order to function
properly.
If
the unit is not leveled
during
installation,
the door may be misaligned
and not close
or seal properly,
causing
cooling,
frost, or
moisture
problems.
To Level Your Appliance:
After discarding
crating
screws, use a
carpenter's
level to level the unit from front-
to-back.
Adjust
the plastic
leveling
feet in
front,
1/2 bubble
higher, so that the door
closes easily when left halfway
open.
Cleaning (Prior to use)
° Wash
any removable
parts, the appliance
interior,
and exterior
with mild detergent
and warm
water.
Wipe
dry. Do net use
harsh cleaners
on these surfaces.
* Do not use razor
blades
or other
sharp instruments, which can scratch
the appliance
surface
when removing
adhesive
[abels.
Any glue left from the
tape
can be removed
with
a mixture
of
warm
water
and mild detergent,
or touch
the residue with the sticky
side of tape
already
removed.
Do not remove the
serial
plate.
6
