Idiomas disponibles
Idiomas disponibles
UNPACKING
CARTON
_I_CAUTION:
Be careful of exposed
staples when handling or disposing of
cartoning material.
IMPORTANT:
When unpacking and
assembling
tiller, be careful of exposed
staples when handling or disposing of
cartoning
material.
1. While holding handle assembly,
cut
cable ties securing handle assembly
to top frame.
Let handle assembly
rest on tiller.
2.
Remove
top frame of carton.
3. Slowly
ease handle
assembly
up and
place on top of carton.
4.
Cut down right hand front and right
hand rear corners
of carton,
lay side
carton
wall down.
5.
Remove
packing
material
from handle
assembly.
6.
Separate
shift rod from handle
assembly.
Assembly
INSTALL
HANDLE
1. Insert one handle lock (with teeth
facing
outward) in geamase
notch.
(Apply grease on smooth side of
handle lock to aid in keeping lock in
place until handle assembly is
lowered into position.)
VIEWED FROM R.H. SIDE OF TILLER
Ha-
Hand'e
Assernbly
arcase Notch
ndle Lock
2. Grasp
handle
assembly.
Hold in "up"
position. Be sure handle lock remains
in geamase
notch.
Slide handle
assembly
into position.
3.
Rotate handle assembly down.
Insert
rear carriage bolt first, with head of
bolt on L.H. side of tiller and loosely
assemble
Iocknut.
,_'"
:::_-,,._J., ,,:',,'_ Handle Assembly
!' _
i:,.:_::_.,,/
"UP" Position
<_'k'_
_..
Tighten handle
_-_'_.i",
lock lever tllpo h old
Loosen Handle Lo_
4.
Insert pivot bolt in front part of plate
and tighten.
5. Cut down remaining corners of carton
and lay panels flat.
6.
Lower the handle assembly.
Tighten
nut on carriage bolt so handle moves
with some resistance.
This will allow
for easier adjustment.
7.
Place flat washer on threaded end of
handle lock lever.
8.
Insert handle lock lever through
handle base and gearcase.
Screw in
handle lock lever just enough to hold
lever in place.
9.
Insert second handle lock (with teeth
inward) in the slot of the handle base
(just inside of washer).
10. Raise
handle assembly
to highest
position
and securely
tighten
handle
lock lever by rotating clockwise.
Leaving
handle
assembly
in highest
position will make it easier to connect
shift rod.
Flat Washer
Handle Lock
Handle Lock
Lever
Gearcase_
Slot
Rear Cartridge
Handle Base
Locknut j
J
Pivot Bolt
6
