Idiomas disponibles
Idiomas disponibles
Your new tiller has been assembled
at the
factory with the exception of those parts
left unassembled
for shipping purposes.
To ensure
safe and proper operation
of
your tiller all parts and hardware
you
assemble
must be tightened
securely.
Use the correct
tools as necessary
to
insure
proper tightness.
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier.
Standard wrench sizes are listed.
(1) Utility knife
(1) Wire cutter
(1) 13re pressure gauge
(1) Screwdriver
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR'S
POSITION
When right or left hand is mentioned
in
this manual, it means when you are in the
operating
position
(standing
behind tiller
handles).
LEFT
FRONT
OPERATOR'S
POSITION
RIGHT
CONTENTS OF HARDWARE PACK
(2) Handle Locks
(1) Hairpin
Clips
(2) Shear Pins & Clips
(1) Carriage
Bolt
3/8-16
UNC
x 1 Gr. 5
(1) Flat Washer
13/32
x 1 x 11 Ga.
©
(1) Center
Locknut
3/8-16
UNC
(1) Cable Clip
(1) Pivot Bolt
3/8-16
UNC
Grade
5
(1) Handle Lock Lever
5
