Idiomas disponibles
Idiomas disponibles
A wide fan pattern will distribute the impact of the water over a larger area, resulting in excellent
cleaning action with a reduced risk of surface damage, Large surface areas can be cleaned more
quickly using a wide fan pattern.
NOZZLE CLEANING INSTRUCTIONS
A clogged or partially clogged nozzle can cause a significant reduction of water coming out of the
nozzle and cause the unit to pulsate while spraying. To clean out the nozzle:
• Turn off and unplug unit.
• Turn off water supply. Relieve any pressure trapped in the hose by squeezing trigger 2-3 times.
• Separate lance from gun.
• Rotate nozzle to the narrow stream setting. This opens up the fan blades.
• Using included tip cleaner, or an unfolded paper clip, insert wire into the nozzle hole and move
back and forth until debris is dislodged. (See Figure 5.)
• Remove additional debris by back-flushing water through the nozzle. To do this, place end of a
garden hose ( with water running ) to end of nozzle for 30-60 seconds.
ANGLE TO THE CLEANING SURFACE
When spraying water against a surface, maximum impact is gener en the water strikes the surface
"head on."
However, this type of impact tends to cause dirt particles to imbed in the surface, thereby preven-
ting the desired cleaning action.
The optimum angle for spraying water against a cleaning surface if 45 degrees.
8
