Daewoo DAX105-1400 Manual De Uso página 11

Hidrolavadora de alta presión
Ocultar thumbs Ver también para DAX105-1400:
Idiomas disponibles

Idiomas disponibles

EN
5. Apply detergent so it thoroughly covers cleaning surface. Apply from bottom to top to prevent
detergent from sliding down and streaking.
6. Allow detergent to remain on the surface for a few minutes. This is a good time to use a brush to
lightly scrub heavily soiled areas.
Never allow detergent to dry on the cleaning surface.
7. Remove detergent applicator from gun and replace with the lance, or remove applicator from end
of lance.
8. Rinse detergent from surface.
NOTE: Flush detergent applicator with clear water following each use.
4. Final Rinse
start final rinse at bottom an work upward. Make sure you thoroughly rinse the surface
and that all detergent has been removed.
5. Shut down
1. Be sure all detergent is flushed from system.
2. Turn off motor.
3. Turn off water supply.
4. After motor and water supply are turned off, trigger gun to depressurize system.
CAUTION: NEVER turn water supply off before turning motor off. Serious damage could occur to the
pump and or motor.
WARNING! NEVER disconnect high pressure discharge hose from machine while system is pressu-
rized. To depressurize, turn motor off, turn water supply off and squeeze gun trigger 2-3 times.
5. After each use, wipe all surfaces of the pressure washer with a clean, damp cloth.
6. Storage
Do not store pressure washer outdoors.
Do not store pressure washer where it might freeze.
TIPS FOR EXTENDING THE LIFE OF YOUR PRESSURE WASHER
1. Never operate unit without water.
2. Pressure washer is not meant to pump hot water. Never connect to hot water supply – this will
significantly reduce life of the pump.
3. Using detergent other than others brand may cause damage to pump components (o-rings,
etc.).This also applies to chemicals such as bleach, dish soap, etc.
4. Never operate unit for more than one (1) minute without spraying water. Resulting heat buildup will
damage pump.
5. Before adjusting nozzle's pressure (high-to-low or low-to-high) release trigger.
Failure to do so will reduce life of o-rings in lance.
11
loading