Disposal And Recycling - Dunsch DU51794B3 Manual De Instrucciones

1) Type of machine
2) Article number of the machine dentification number of the machine
3) Replacement part number of the part required

DISPOSAL AND RECYCLING

The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to the raw material system.The unit and its accessories
are made of various types of material, such as metal and plastic. Defective components must be disposed
of as special waste. Ask your dealer or your local council.
PROBLEMS
Power loss or sudden stopping of the engine
Check whether the fuel tank is empty.
The mixture does not reach the carburetor. Clean the fuel filter in the fuel tank.
There is water in the mixture. Drain and rinse all the fuel system.
The air filter is dirty. Clean the air filter.
There are carbon deposits in the cylinder exhaust pipe or the muffler. Clean those or change the
muffler.
Starting a flooded engine
Disconnect the spark plug lead, and use the plug wrench to remove the spark plug in a counter
clockwise direction.
If the spark plug is fouled or is soaked with fuel, clean or replace the plug as required.
Clean excess fuel from the combustion chamber by cranking the engine several times while the
spark plug is removed.
Install the spark plug and firmly tighten it with the spark plug wrench.
Repeat the starting procedure as if the blower was already warm.
If the engine won't stop
If the engine continues to run after switching the on/off switch to off, stop the engine by pushing the choke
lever to the fully closed position. If this condition continues, have the blower serviced before using it again.
22