Idiomas disponibles
Idiomas disponibles
DELAY FUNCTION
1. First follow steps 1 through 5 above (Using your coffee machine).
2. Press PROGRAM one time, the ON/OFF indicator light will
illuminate to GREEN and will flash until you have set delay time.
3. Set the delayed start time by pressing HOUR and MINUTE
buttons until you reach delayed time desired.
4. Next, press the DELAY BREW button, the ON/OFF indicator light
will still be GREEN but will stop flashing.
5. After a few seconds, the LED will display the current time.
6. When the delayed brew time begins, the ON/OFF indicator light
will illuminate to RED.
7. You may see the delay brew time by pressing DELAY BREW.
8. Cancel DELAY BREW by pressing ON/OFF.
9. If you want to change the delay brew time, follow steps 2 through
4 above.
10. The brewing process may be interrupted 2 ways;
a. Pressing the ON/OFF button (must press again to continue
brew)
b. Pulling out the coffee pot (must return to warming plate
within 30 seconds)
11. All other functions (PROGRAM, DELAY BREW, HOUR/MINUTES)
are not available during the brewing process.
12. Remove coffee pot to serve when finished brewing (about 1
minutes after coffee stops dripping).
13. If all coffee will not be served immediately, the coffee can be kept
warm on the warming plate. The coffee maker will automatically
shut off after 40 minutes from when the ON/OFF button was
pressed, if it hasn't been manually turned off.
14. Use caution while pouring coffee out of pot, as contents will be
very hot!
15. Always turn off the coffee maker and disconnect the power
supply when not in use.
www.haden.com
10
CLEANING & MAINTENANCE
CAUTION: Be sure to unplug this appliance before cleaning.
To protect against electrical shock, do not immerse cord, plug or
unit in water or liquid. After each use, always make sure plug is first
removed from wall outlet.
1. Clean all detachable parts after each use in hot soapy water.
2. Wipe the exterior surface of unit with a soft, damp cloth to
remove stains.
3. Water droplets may build up in the above area of the funnel
and drip onto the product base during brewing. To control the
dripping, wipe off the area with a clean, dry cloth after each use.
4. Use a damp cloth to gently wipe the warming plate. Never use
abrasive cleaner to clean it.
5. Replace all parts and keep for next use.
REMOVING MINERAL DEPOSITS
To keep your coffee maker operating efficiently, periodically you
should clean away the mineral deposits left by the water according
to the water quality in your area and the frequency of use.
1. Fill the tank with water and descaler to the max level as indicated
on water gauge (the mix of water and descaler is 4:1, the detail
refers to the instruction of descaler. Please use "household
descaler", you may also use the citric acid instead of the descaler
(One hundred parts of water to three parts of citric acid).
2. Place the serving cup under the brew basket.
3. Ensure the funnel is assembled in place.
4. Switch on the appliance and "brew" the de-scaling solution.
5. After "brew" one-cup solution, switch off the appliance.
6. Leave the solution for 15 minutes and repeat step 3-5.
7. Switch on the appliance and run off the solution until the water
tank is completely empty.
www.haden.com
11
