Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART:
See appropriate section in manual unless directed to Sears service center
CAUSE
1
Weak or dead battery.
2
Corroded battery terminals.
3
Loose or damaged wiring.
4
Faulty solenoid or starter.
1
Cutting too much grass/too fast.
2
Throttle in "CHOKE" position.
3
Build-up of grass, leaves and
trash under mower.
4
Dirty air filter.
5
Low oil level/dirty oil.
6
Faulty spark plug.
7
Dirty fuel filter.
8
Stale or dirty fuel.
PROBLEM
Engine dicks
but
will not start
Loss of power
Excessive
vibration
Engine continues to
run when operator
leaves seat with
attachment
clutch
engaged
Water in fuel.
10
Spark plug wire loose.
11
Dirty engine air screen/fins.
12
Dirty/clogged muffler.
13
Loose or damaged wiring.
14
Carburetor out of adjustment.
15
Engine valves out of adjustment.
1
Worn, bent or loose blade.
2
Bent blade mandrel.
3
Loose/damaged
part(s).
Faulty operator-safety
presence
control system.
CORRECTION
1
Recharge or replace battery.
2
Clean battery terminals.
3
Check all wiring,
4
Check/replace solenoid or starter.
1
Raise cutting height/reduce
speed.
2
Adjust throttle control.
3
Clean underside of mower
housing,
4
Clean/replace air filter.
5
Check oil level/change oil.
6
Clean and regap or change spark
plug,
7
Replace fuel filter.
8
Empty fuel tank and refill tank with
fresh, clean gasoline.
9
Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
10 Connect and tighten spark plug
wire.
11 Clean engine air screen/fins.
12 Clean/replace muffler.
13 Check all wiring.
14 See "To Adjust Carburetor" in
Service and Adjustments section.
15 Contact a Sears or other qualified
service center,
1
Replace blade. Tighten blade bolt.
2
Contact a Sears or other
qualified service center.
3
Tighten loose part(s).
Replace damaged parts,
1
Check wiring, switches and
connections, If not corrected,
contact a Sears or other
3O
