Idiomas disponibles
Idiomas disponibles
Installation Steps
Turn off the power at fuse or circuit box
1. Unscrew the two bolt nuts (D). Remove the two rubber pads (E) and the mounting plate unit (A) from the backplate .
2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B). Adjust the length of the
preinstalled fixture mounting screws if necessary.
Note: Make sure that the fixture mounting screws are lined up horizontally to make the fixture level.
3. Install the bulb (not included). Check relamping label at socket area or packaging for maximum wattage allowed.
4. Attach the dome onto the frame by aligning threaded pipe and inserting the two rubber pads-a, then secure them
with the two bolt nuts-a.
5. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
• Connect the hot wire (black insulation) from the fixture to the black wire from the power source.
• Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.
• Attach the fixture ground wire (bare wire) to the mounting plate unit (A) with the green ground screw, then
depending on local code, connect it to the house ground wire with the wire connector (C).
Carefully put all of the wires back into the outlet box.
6. Attach the backplate of the fixture to the mounting plate unit (A) by inserting fixture mounting screws into set holes
on the backplate, then secure it with two rubber pads (E) and two bolt nuts (D).
Note: With silicone caulk compound, caulk completely around where the backplate meets with the wall
surface to prevent water from seeping into the outlet box.
Turn on the power at fuse or circuit box.
Function and Operation
MODES OF OPERATION
Choose a mode by sliding the slide switch. The light will turn on immediately when power is applied. Wait for 30
seconds to allow the sensor to warm up.
1. TEST MODE (daytime and nighttime operation.)
● Rotate the knob on the bottom of the backplate to the "TEST" position, the light will turn on when motion is
detected, and stay on as long as the motion continues. The light will turn to low-level brightness (30%) after 5
seconds when motion is no longer detected.
2. Off MODE (nightime operation only)
● Select "Off" mode, rotate "TIME" delay knob arrow to point to the desired time setting (between 5 seconds and 3
minutes). At dusk, the light turns off. When motion is detected, the light turns to full brightness and stays on as
long as motion continues. When the motion is no longer detected, the light will stay on for the predetermined time
you set, then the light will turn off.
3. AUTO MODE (nighttime operation only)
● Select "Auto" mode, rotate "TIME" delay knob arrow to point to the desired time setting (between 5 seconds and 3
minutes). At dusk, the light turns on to pre-selected low level brightness (30%). When motion is detected, the light
turns to full brightness and stays on as long as motion continues. When the motion is no longer detected, the light
at full brightness remains on for the predetermined time you set.
4. PC MODE (nighttime operation only)
● The light will turn on automatically at dusk and turn off at dawn.
Page 2 / 4
231011
