Idiomas disponibles
Idiomas disponibles
Original manual FUXTEC 20V FX-E1KS20 rev03
Switching the device on/off
Insert the battery into the slot provided. Then push the safety button (Figure 1, item 12) in at the
side. Only then you can operate the on/off switch (Figure 6, item 2). The device will now start up. If
you release the on/off switch, the device stops working.
Attention: The cutting tool can still run shortly afterwards.
Operating notes
WARNING!
Before each use, check that the chain brake is working properly. Otherwise, do not use the chainsaw
and have it repaired by a FUXTEC technician.
The chainsaw has a chain brake as a protective equipment, which stops the chain in a fraction of a
second in the event of a kickback. In the event of a kickback, the chain brake is automatically
activated by contact of the hand guard with the left hand. Therefore, always hold the chainsaw with
both hands.
Manual activation and release of the chain brake
Tilt the hand guard in the direction of the saw-bar tip (see following figure).
To release the chain brake, pull the hand guard towards the handle (see following figure).
34
