Garland BULK KEEPER 20V 108 Manual De Instrucciones página 38

English
6.5.4. CHAIN TENSIONING
This machine has a quick and easy manual chain
tensioning system, without the use of tools.
Always disconnect the battery from the chainsaw
before doing any work on it.
To avoid injury from sharp cutting edges, always wear
gloves when mounting, tensioning or checking the
chain.
Chain tension:
1. Make sure the chain is inside the guide groove of
the guide bar.
2. Loosen the lock nut (8) without removing the cover.
3. Turn the chain tensioner (15) in the (+) direction to
tighten or in the (-) direction to slack the chain until
the chain tension is correct.
a. Example (A) corresponds to a chain that is too tight.
b. Example (B) corresponds to a chain that is too
slack.
4. Hand-tighten the lock nut (8). Do not overtighten
the chain.
6.6. STARTING AND STOPPING
Power on the machine:
install the battery
Push the chain brake to the operating position.
Press the on/off button ().
Then press the safety button and, without releasing it,
press the throttle trigger.
Disconnection of the machine:
Release the throttle trigger, allow the chain to stop
rotating and press the on/off button. Then remove the
battery if you are not going to use it for a long time.
Do not start and stop the machine repeatedly in a
few seconds, you will put heavy work on the engine,
generate a lot of heat and decrease the life of your
engine and battery. We recommend that each time
you stop the machine, wait at least 5 seconds before
restarting it.
6.7. CHECK POINTS AFTER START-UP
6.7.1. ANTI-REBOUND PROTECTION VERIFICATION
Chainsaw kickback is the most significant
hazard on this machine. This machine has
an automatic safety brake to stop the
rotation of the chain in the event of an unexpected
kickback during use.
38/128