Idiomas disponibles
Idiomas disponibles
The position you select for the refrigerator installation should be well-ventilated and has less hot air. Do not locate the
refrigerator near a heat source such as cooker, boiler, and avoid it from direct sunlight, thus guaranteeing the refrigeration
effect while saving energy consumption. Do not locate the refrigerator in the damp place, so as to prevent the refrigerator
from rusting and leaking electricity. The result of the refrigerant charge amount of the refrigerator being divided by
the total space of the room in which the refrigerator is installed shall be less than 8g / m³.
Note: The amount of refrigerant charged for the refrigerator can be found on the nameplate.
2.
Heatdissipationspace
When working, the refrigerator gives off heat to surroundings. Therefore, at least 30mm of free space should be spared at
the top side, more than 100mm on both sides, and above 50mm at the back side of the refrigerator.
Dimensions in mm:
W
D
595
635
Note：Figure 1, Figure 2 only illustrate the space demand of the product
3.
Levelground
Place the refrigerator on the solid and flat ground (floor) to keep it stable, or else, it will give rise to vibration and noise.
When the refrigerator is placed on such flooring materials as carpet, straw mat, polyvinyl chloride, the solid backing plates
should be applied underneath the refrigerator, so as to prevent color change due to heat dissipation.
Unobstructed ventilation shall be maintained around the appliance or in an embedded structure.
4.
Standing time
After the refrigerator is properly installed and well cleaned, do not switch it on immediately. Make sure to energize the
refrigerator after more than 1 hour of standing, so as to ensure its normal operation.
5.
Cleaning
Confirm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.
6.
Power-on
Insert the plug into the solid socket to start the compressor. After 1 hour, open the freezer door, if the temperature inside
the freezer compartment drops obviously, it indicates the refrigeration system is working normally.
7.
Storage offood
After the refrigerator runs for a period of time, the internal temperature of the refrigerator will be automatically controlled
according to the user‟s temperature setting. After the refrigerator is fully cooled, put in foods, which usually need 2~3
hours to be fully cooled. In summer, when the temperature is high, it takes more than 4 hours for the foods to be fully
cooled (Try to open the refrigerator door as less as possible before the internal temperature cools down).
If the refrigerator is installed in the moisture place, make sure to check whether the ground wire and leakage circuit
breaker are normal. If vibration noises are produced due to the refrigerator contacting the wall or if the wall gets blackened
by air convection around the compressor, move the refrigerator away from the wall. Setting up the refrigerator may cause
jamming noise or image chaos to the mobile phone, fixed-line telephone, radio receiver, television set surrounding it, so
try to keep the refrigerator as far away as possible in such case.
Functions
The display panel is designed on the fridge door, the pattern of which is displayed as the right Figure.
When the refrigerator system is connected to power supply for the first time, all icons on the display panel gets illuminated
for 2s.
When all the doors are close, the display gets extinguished automatically if no key operation within 3 minutes. When the
display is off, it will light up if any door is opened or any key is pressed.
The following key operations are valid only when the keys are unlocked and gets illuminated on the display.
★Temp. setting
1）Fridge temperature setting
H
A
2000
966
B
C(°)
1202
130
E
F
50
100
