Imesa IM6 Instrucciones De Uso página 30

E030101C
The connection on the machine must be carried
out as follow:
- turn off the machine through the general
main switch
- make a bridge between the modem serial
door (RS232 at nine pins female) and the
washing machine serial door (RS232 at
nine pins male), with the supplied cable
(figure 5).
- Connect a home phone line (remove it
from a telephone) to the telephone
modem line (see figure 4). Attention the
correct pin is the left one.
- Connect the pin to the electric power to
alimentation modem (see figure 2).
- Connect the pin to the electric power
supply of the modem power pack, and the
power pack to the plug (230V, 50Hz).
- Turn on the modem though the general
main switch (figure nr.1) the modem is on
when turned up.
- Trun on the machine using the main
switch.
When the connections are completed, supply
power to the machine. On remote PC, set up the
"WIZARD" program and select the modem
communication clicking on the icon:
Fill in the communication parameters windows
and click on "CLOSE" to initiate the telephone
communication. When
completed, it is possible to implement all the
normal programming and diagnosis operation,
illustrated on the previous paragraphs, from the
remote PC.
The same system is done for machines with GSM.
For the SMS information call the installer
technician.
28. MESSAGES ON DISPLAY
Here below please find listing of
the connection is
display
messages.
PLEASE NOTE that all servicing must be carried
out by authorized service staff.
ALL1 - is displaied when motor over-heating
occurs. To reset it is enough to switch machine
off.; call assistance for help.
ALL2 - door opened during operation. To reset
just turn-off machine; call assistance for help.
ALL3 – temperature probe failure: call assistance
for help
ALL4 – max. allowed step time
assistance for help.
ALL5 – max allowed time for water drain expired:
call assistance for help
ALL10 – one or more side-panels of the machine
are open
END – washing programme is over;
controls are being carried-out for door lock
release
END TEMP -
temperature is above 40° C at the end of a
programme. Alert will be reset with water temp.
below 40° C
END H20 – is displaied when water level is above
5 cms at the end of a programme. Alert will be
reset after draining.
INVERTER LOCKED - When the inverter is
blocked, if the drum does not run , switch
off the machine, through the general
switch and wait for some seconds before
restarting it on. If the drum runs regurarly
waith for the end of the programme. With
the starting of the new programme the
message disappears. If the message
often appears,
assistance.
MAINTENANCE - when the machine has done
the sufficient number programmes to
demand a checking. (1000 for default).
Call the technical service.
DOOR OPEN – is displaied when machine has
opened door
POWER FAIL – is diplaied if electricity supply is
interrupted. It is enough to press "START"
UNBAL – is displaied when linen load is
unbalanced; in this case a balancing cycle
will re-start spinning for three more times,
after which spinning will be skipped and
programme will start from the following
cycle
SELECT PROGRAMME –
door is
machine will stand by until a programme
is chosen
SPEED FLASHING - when the value of the speed
i flashing at display, it means that the
machine is doing the spin cycle and the
water level is over the maximum allowed.
30
30/11/2003
expired: call
is displaied when
call the Technical
is displaied when
open; microprocessor
safety
water
and