ROCK JAM MIDI RJMK25 Guia Del Usuario página 10

display. When all the PADs have been configured, release the PAD Setting button to
exit the edit mode.
11. Loop: Press and hold the Loop button while playing some notes. When the Loop
button is released the notes will start to Loop repeatedly.
12. Note Repeat: Press this button to enter Note Repeat mode. Striking a pad and
then holding it will cause the pad to retrigger at a rate based on the current Tempo
and Time Division settings. Press and hold the Note Repeat button to make changes
to the Tempo, Time Division and Swing settings, using the control knobs or the keys.
13. Bank A/B: Press this button to switch pads between Pad Bank A or Pad Bank B.
14. Full Level: Press this button to activate or deactivate Full Level Mode in which the
pads always play at a maximum velocity (127), no matter how hard or soft you hit
them.
15. Keyboard: This keyboard has 25 velocity-sensitive keys and in conjunction with
the Octave Down / Up buttons, can control a ten-octave range.
16. Sustain Pedal Input: Connect an optional 6.35 mm TS sustain pedal to this input.
NOTE: Connect the pedal first before powering on the MIDI controller to ensure
correct operation.
17. MIDI Out: Plug a 3.5mm TRS cable (not supplied) into the back of the MIDI
controller for use with external synthesisers. This controller uses the Type A MIDI
connection standard.
18. On/Off: Slide the ON/OFF switch to turn the power on and again to turn the
power off. The display will light up to indicate power on.
19. USB: Unwind the USB power cable to its full length; connect one end to the
USB C Socket on the back of the MIDI controller. Connect the other end to a USB
power adapter or PC USB port. The charge indicator LED on the back of the MIDI
will light up red to indicate charging and will go green when fully charged.
Charge for at least 3 hours before first use. Also use for a USB MIDI connection to a
host computer or tablet device.
10