Idiomas disponibles
Idiomas disponibles
Operation
Vacuuming
Dry Materials
WARNING:
Be sure to read, understand
and apply all the information in the
important
Safety instructions
section at the beginning of this operator's
manual.
Do not vacuum in areas with flammable
gases, vapors, or explosive
dusts in the
air. Flammable
gases or vapors include but are not limited to: lighter fluid,
solvent type cleaners, oil=base paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not limited to: coal, magnesium,
grain or gun
powder.
To reduce the risk of health hazards from vapors or dust, do not
vacuum toxic materials.
1. Verify that the power cord is
disconnected
from the outlet. (Fig. 1)
2. In order to prepare your vacuum for dry
vacuuming, verify that the cartridge filter
is securely mounted. Make sure the filter
is pushed in until it stops against the
power head. (Fig. 2) (Your Wet/Dry Vac
comes with the cartridge filter pre=
installed, if not, see page 10 for
installation instructions.)
3. Place filter retainer on top of cartridge
filter and tighten by turning the retainer
handle clockwise. (Fig. 3)
4. Optional, for improved dust filtering, fit
collection dust bag flange onto the inlet
stub, taking care not to damage the bag.
(Fig. 4)
5. Place the power head back on the
collection tank, aligning the top section
with the latches, and lock into place.
(Fig. 5)
6. insert the locking end of the hose into
the vacuum port and screw in place.
Push the desired extension wands or
attachments onto the free end of the
hose. (Fig. 6)
7. Verify that the switch is in the 'O' OFF
position before plugging the power cord
into the outlet. (Fig. 7 & 8)
8. Turn the motor on by pressing the switch
to the 'l' ON position. (Fig. 9)
9. Once you have completed vacuuming,
press the switch to the 'O' OFF position
and unplug the power cord from the
outlet. (Fig. 10 & 11)
0 = OFF
I = ON
DO NOT USE THE CARTRIDGE FILTER
AND THE DUST COLLECTION BAG FOR
LIQUID VACUUMING.
CAUTION: Do not vacuum drywall dust,
fireplace soot or ash with standard Wet/
Dry filter. This is very fine dust which will
not be captured by the filter and may cause
damage to motor. When vacuuming fine
dust use a fine dust filter (sold separately).
