Idiomas disponibles
Idiomas disponibles
5.4. SPECIFIC CONFIGURATION FOR USE WITH CAD-COMPACT HEAT RECOVERY
The characteristics of the heat recovery units in the CAD-COMPACT range have particularities that make a specifi c
control confi guration necessary:
EN
Switched by-pass servomotor
The servomotor used requires separate outputs for opening and closing. It is therefore necessary to confi gure both
output relays for the by-pass function.
Temperature probes
The CAD-COMPACT heat recovery include air temperature probes, so it is not necessary to wire the probes supplied with
the CAD-REG Control.
To use the CAD-REG with CAD-COMPACT heat recovery, the following confi guration must be performed:
Advanced parameters:
Parameter
9
* Selection based on the existence of a CO
Relay confi guration:
Parameter
2
6. USE OF THE CONTROLLER. USER MODE
Once voltage is supplied to the controller, the display will show different icons which indicate its status as well as the
functionalities that are active:
1. Information about the status of the fans
2. Information about the operation mode
32
Function
Confi guration of temperature probes and CO
sensor and its type.
2
Relay 1
On/off by-pass
Fans stopped by manual stop
Fans stopped due to time programming
Numerical value, corresponds to the fan speed expressed
in % over maximum speed
Outdoor air temperature
Indoor air temperature
MANUAL STOP
both indicators
Off
sensor
2
Relay 2
On/off by-pass
MANUAL START
On
Adjustment range
1, 3 or 5*
AUTOMATIC
On
