Preparation For Use - SAKAWA SP42 Manual

3.PREPARATION BEFORE USE
3.1. Check Engine Conditions
3.1.1. Check that you don't spill liquids or gasoline
3.1.2. Remove soil fragments, especially near the exhaust and start-up.
3.1.3. Check for damage
3.1.4. Make sure the plug is tight, and the connection is firm.
3. 2. Connect the water inlet
• Use general gaskets and loops.
• The water inlet should be continuous and the structure should not bend. The
length of the water inlet should not be more than required. The pump will
work optimally when the distance between the pump and the water source
are not far away. The suction time is directly proportional to the length of
the water inlet.
• The filter should be fitted at the end of the water inlet as shown in the
illustration.
Attention:
• Before pumping, adjust the filter.
• Tighten the gaskets and clips, make sure the water inlet is tightened and
no air is lost.
3.3. Connect the Water Outlet Pipe
• Use the general gaskets and clips to connect the water outlet pipe , and
make sure the loops are tight .