Makita HK1820 Manual De Instrucciones página 5

Installing or removing the bit
1
► 1. Bit 2. Chuck cover
Clean the bit shank before installing the bit.
Insert the bit into the tool. Turn the bit and push it in until
it engages.
1
► 1. Chuck cover
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
Bit angle
2
► 1. Change ring
► 1. Change ring
The bit can be secured at 12 different angles. To
change the bit angle, slide the change ring forward,
then turn the change ring to change the bit angle. At the
desired angle, slide the change ring back to the original
position. The bit will be secured in place.
Hook
► 1. Hook 2. Power supply cord 3. Extension cord
When connecting the power supply cord to an extension
cord, use the hook so that the plug of power supply cord
cannot be disconnected from the connector of exten-
sion cord. Set it on the extension cord 10 cm - 20 cm (4"
- 8") away from the connector of the extension cord.
5 ENGLISH
1
1
1
2
3