Idiomas disponibles
Idiomas disponibles
Thanks for purchasing this ZZIPP product, please read this instruction carefully to
understand how to operate the product correctly. Please store this instruction in a safe
place after reading as a reference in the future.
SAFETY INSTRUCTIONS
To reduce the risk of fire and electric shock, do not expose the appliance to moisture and
direct contact with liquids.
This symbol, wherever used,alerts you to the presence of un-isulated and
dangerous voltages within the product enclosure. These are voltages that may
be sufficient to constitute the risk of electric shock.
This symbol, wherever used, alerts you to important operating and mainte-
nance instructions. Please read.
WARNING Describes precautions that should be observed to prevent the possibility of
death or injury to the user.
CAUTION
Describes precautions that should be observed to prevent damage to the
product.
Power Supply Ensure that the mains source voltage (AC outlet) matches the voltage rating
of the product. Failure to do so could result in damage to the product and
possibly the user. Unplug the product before electrical storms occur and when unused for
long periods of time to reduce the risk of electric shock or fire.
External Connection Always use proper ready-made insulated mains cabling (power cord).
Failure to do so could result in shock or fire. If in doubt, seek advice from a registered
electrician.
Do not Remove Any Cover Within the product are areas where high voltages may
bepresent. To reduce the risk of electric shock do not remove any covers unless the AC
mains power cord is removed.
Covers should be removed by qualified service personnel only. No user serviciable parts
inside.
Fuse To prevent fire an damage to the product, use only the recommended fuse type as
indicated in this manual. Do not short-circuit the fuse holder. Before replacing fuse, make
sure that the product is OFF and disconnected from the AC outlet.
Protective Ground Before turning the product ON, make sure that it is connected to
Ground. This is to prevent the risk of electric shock. Never cut internal or external Ground
wires. Likewise, never remove Ground wiring from the Protective Ground Terminal.
Operating Conditions Always install in accordance with the manufacturer´s instructions.
To avoid the risk of electrtic shock and damage, do not subject the product to any liquid/
rain or moisture. Do not use this product when in close proximity to water.
Do not install this product near any direct heat source. Do not block areas of ventilation.
2
