Idiomas disponibles
Idiomas disponibles
7.
CONTROLS AND
INDICATORS
B
C
3
2
A-Programme Selector - Rotating the knob
in both directions it's possible to select the
desired drying program. To cancel the
selections or switch off the dryer rotate the
knob on OFF.
B- Display Digit - The display shows the
remaining time for drying, the postponed
time in case of delayed start selection and
other notifications setting.
C-Buttons -
1.Start/Pause Button
To start the selected program and/or
suspend it.
2.Time cycle selection
It's possible transform a cycle from automatic
to programmed, up to 3 minutes after the
start of the cycle. The progressive pressure
increases the time in 10-minute intervals.
After this selection to reset the automatic
dying functioning is necessary to switch off
the dryer In case of incompatibility, all LEDs
flash quickly for 3 times.
3.Delay Start Button
It allows to delay the start of the program
from 1 to 24 hours in 1-hour intervals. The
delay selected is shown on the display.
After pressing the START button the time
showed decrease hour after hour.
A
E
D
4
6
1
1
5
7
8
Opening of the porthole with delayed start
set, after re-closing the porthole, press start
again to resume the counting.
4.Drying Selection Button
It allows
to set the desired dryness level
editable option up to 5 minutes after the
starting of the cycle:
- Ready to Iron : It leaves the garments
slightly wet to facilitate ironing.
- Dry Hanger : To get garment ready to be
hang
- Dry wardrobe : For laundry that can be
directly stored
-Extra-dry : To get completely dry
garments, ideal for full load.
This appliances is equipped with Drying
Manager Function. On automatic cycles,
each level of intermediate drying, prior to the
reaching the selected one, is indicated by
flashing the light indicator corresponding to
the degree of drying reached In case of
incompatibility, all LEDs flash quickly for 3
times.
5.Rapids Button
It's possible switch an automatic program to
RAPID program, up to 3 minutes after the
start of the cycle. The progressive pressure
increases the time (30-45-59 minutes).
After this selection to reset the automatic
dying functioning is necessary to switch off
the dryer In case of incompatibility, all LEDs
flash quickly for 3 times.
6.Anti crease
This option allows to activate an anti-creases
movement of the drum pre cycle in case of
activation of the delay and
drying cycle. It is activated every 10 minutes,
up to 6 hours after the end of the drying cycle.
To stop the movements set the knob to OFF.
Useful when it's not possible to remove
immediately.
7. Keylock
This function allows to block unwanted
changes of the set options on the bezel ,
during drying phase.
Activation/ Inactivation: Push 4 and 5 buttons
simultaneously for two seconds . The sign
"LOC" appears on the display. Unlocking the
option, on the display appears the sign "Unl",
only once. In case of opening of 'porthole' with
activated key lock, the cycle stops but the lock
is kept: to restart the cycle, you must remove
the lock and restore Start. When the dryer is
off, the option is automatically inactivated.
Key lock can be modified at any time of the
cycle.
12
12
at the end of
