Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
3. PAIRING WITH THE CONNECTED THERMOSTAT
After inserting the cables into your receiver's terminal blocks, reclose the protective housing to
insulate the connections. Ensure that the white sheath is properly inserted, to ensure that it is
held in place over time. Switch the power on again. The LEDs will flash.
14
Press and hold the receiver's "PROG" button for 3 seconds to pair a boiler, heat
pump, floor heating or pilot wire radiator. The "Connection
to flash green, and pairing mode will be active for 10 minutes. If you want
to pair an independent hot water tank, press and hold the Prog button for 6
seconds; the green LED will flash again.
Approach the front panel of the radio receiver's thermostat, and briefly press
the "PROG" button situated on top of the thermostat's battery compartment.
While searching for the receiver, the thermostat's blue and red LEDs will flash
quickly. Wait for a few seconds.
If the blue LED has flashed 3 times, the pairing has been successful. On the
receiver, the connection LED will remain continuously green.
If the red LED has flashed 3 times, an error has occurred during pairing. Please
begin the pairing procedure again.
Copyright
©
2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
Radio receiver
" LED will begin
Tabla de contenido
