Idiomas disponibles
Idiomas disponibles
Key (with indicator)
ON/OFF
ICE
ICE FULL
ADD WATER
BEFORE FIRST USE
BEFORE FIRST USE
1.Unpack the appliance, then check and make sure that all the accessories
including ice basket and ice scoop etc. are complete. Ask qualified technician
for help for any trouble.
2.Please ensure the ice maker is level and on a stable table or platform to
avoid malfunction.
3.The incline angle of the ice maker cabinet should not exceed 45°during
transportation or use. Do not turn the ice maker upside down. Doing so could
cause the compressor or refrigerating system to operate incorrectly. Please
allow time for the fluids in the compressor to settle after the ice maker is
moved or transported. Before using the ice maker for the first time, please
wait for 2 hours after the unit has been leveled and positioned in the proper
place.
4.The appliance must be placed on a dry and level surface with sufficient
ventilation, far from heat sources such as ovens, heaters and corrosive
gases. Leave an about 20 cm clearance on all sides of the ice maker for
proper ventilation.
5.Do not fill the water reservoir with hot water. This may damage the ice
maker. It is best to fill the water reservoir with water of room temperature or
lower.
6.Do not use the appliance at a very cold environment (lower than 5 ).
7.Clean the appliance by following the operation of "CLEANING AND
MAINTENANCE" before operate.
10
Function
Start or stop the appliance
Standby mode: "ICE" indicator blinks;
Working condition: "ICE" indicator lights solidly.
"ICE FULL" indicator lights up when the ice
basket is full.
"ADD WATER" indicator lights up when the
water reservoir is lack of water.
USING YOUR ICE MAKER
1.Ensure that the drain plug at the bottom of water reservoir is closed well.
2.Plug the ice maker into the wall outlet, the "ICE" indicator blinks.
Note: Please make the ice maker be rested for 30 minutes before plug if it
has been moved.
3.Open the top lid and remove the ice basket.
4.Fill the water reservoir with drinking water.
Note: Do not fill above the MAX water level mark.
5.Replace the ice basket and close the top lid.
6.Press the ON/OFF key and the "ICE" indicator lights solidly.
7.The ice-making cycle will last approximately 7-15 minutes, depending on
the ambient temperature and water temperature.
8.The ice-making cycle starts with water being pumped into the ice tray
situated below the evaporator. Over the next 7-15 minutes ice forms on the
evaporator. Once this has completed, the ice tray will tilt backwards and the
remaining water in the ice tray is drained back into the water reservoir. The
ice cubes are then dropped from the evaporator and pushed forward into
the ice basket by the ice shovel. The ice tray will automatically move back
into position under the evaporator and start the next cycle.
9.The "ICE FULL" indicator will light up when the ice basket is full and the
ice maker will stop the ice-making cycle automatically. Gently remove the
ice from the ice basket with the ice scoop. About 5 seconds later, the ice
maker will restart its ice making function automatically.
10.The "ADD WATER" indicator will light up when the water reservoir is lack
of water and the ice-making cycle will stop automatically. At that time,
remove the ice basket and add water to the water reservoir, and then press
ON/OFF key again to restart the ice-making cycle.
11.When you have got your desired amount of ice, stop the ice making
cycle by pressing the ON/OFF key and unplug the unit from the wall outlet.
12.Open the top lid and transfer the ice to a freezer.
Note: The ice will last in the ice maker for up to a 18 hour period, depending
on the ambient temperature.
13.Allow the ice maker to reach room temperature.
14.Suggest replacing the water every a week. Please empty the water
reservoir if the ice maker is not used for a long time.
11
