Idiomas disponibles
Idiomas disponibles
1. With engine not running, move throttle
control lever to fast position.
2. Check that swivel is against stop. If it is
not, loosen cable clamp screw and pull
cable back until swivel is against stop.
Tighten cable clamp screw securely.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be necm
essary. Check adjustment as described
below before loosening cable. If adjustm
merit is necessary,proceed as follows:
1. With engine not running, move choke
control (located on dash panel) to full
choke position.
2. Loosen knob and remove cover as-
sembly from air cleaner.
3. Choke should be closed. If it is not,
loosen casing clamp screw and move
choke cable until choke is completely
closed. Tighten casing clamp screw
securely.
4. Replaceair cleaner cover assembly
and tighten knob.
TO ADJUST CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate properly due to
suspected carburetor problems, take your
tractor to a Sears or other qualified service
center for repair and/or adjustment.
High speed stop is factory adjusted. Do
not adjust - damage may result.
IMPORTANT:Never tamper with the
engine governor,which is factory set
for proper engine speed. Overspeed_
ing the engine above the factory high
speed setting can be dangerous. If you
think the engine_governedhigh speed
needs adjusting, contact a Sears or other
qualified service center which has proper
equipment and experience to make any
necessary adjustments.
Swivel
Clamp
Screw
Clamp
