Idiomas disponibles
Idiomas disponibles
Weak or Dead
Fully Charged
Battery
Battery
REPLACING
BATTERY
_I_I, WARNING:
Do not short
battery
terminals
by allowing
a wrench
or any
other object
to contact
both terminals
at
the same
time.
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands,
rings,
etc.
Positive
terminal
must be connected
first to prevent
sparking
from accidental
grounding.
1.
Lift hood to raised
position.
2.
Disconnect
BLACK
battery
cable
(A)
then RED battery
cable
and carefully
remove
battery
from tractor.
3.
Install
new battery
with terminals
in
same
position
as old battery.
4.
First connect
RED battery
cable
(B) to
positive
(+) battery
terminal
with hex
bolt and keps nut as shown.
Tighten
securely.
Slide terminal
cover
(C) over
terminal.
5.
Connect
BLACK
grounding
cable
to
negative
(-) battery
terminal
with re-
maining
hex bolt and keps nut. Tighten
securely
6.
Close
hood.
Negative
(Black)
Cable
TO REPLACE
HEADLIGHT
BULB
1. Raise hood.
2. Remove bulb holder from the hole in
the backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
iNTERLOCKS
AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
o Check wiring.
See electrical wiring
diagram in the Repair Parts section.
TO REPLACE
FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE
HOOD
AND
GRILL
AS-
SEMBLY
1.
Raise
hood.
2.
Unsnap
headlight
wire connector.
3.
Stand
in front of tractor.
Grasp
hood at
sides,
tilt toward
engine
and lift off of
tractor.
4.
When
replacing
hood,
be sure to re-
connect
the headlight
wire connector.
Headlight Wire
Connector
Positive
(Red)
Cable
ENGINE
Maintenance,
repair, or replacement
of
the emission
control
devices
and systems,
which
are being done at the customers
ex-
pense,
may be performed
by any non-road
engine
repair
establishment
or individual.
Warranty
repairs
must be performed
by an
authorized
engine
manufacturer's
service
outlet.
TO ADJUST
THROTTLE
CONTROL
CABLE
The throttle
control
has been preset
at the
factory
and adjustment
should
not be nec-
essary.
Check
adjustment
as described
below
before
loosening
cable.
If adjust-
ment
is necessary,
proceed
as follows:
26
