Idiomas disponibles
Idiomas disponibles
NOTE:
On rear wheels
only:
align
grooves
in rear wheel
hub and axle.
Insert
square
key.
4.
Replace
washers
and snap
retaining
ring securely
in axle groove.
5.
Replace
axle cover.
NOTE:
To seal tire punctures
and prevent
flat tires due to slow leaks,
purchase
and
use tire sealant
from Sears.
Tire sealant
also
_revents
tire dry rot and corrosion.
Washers
Retaining
Ring
TO CHECK
BRAKE
If tractor
requires
more than five (5) feet to
stop at highest
speed
in highest
gear on a
level, dry concrete
or paved
surface,
then
brake
must be serviced.
You may also check
brake
by:
1,
Park tractor
on a level, dry concrete
or
paved
surface,
depress
brake
pedal
all the way down
and engage
parking
brake.
2,
Disengage
transmission
by placing
freewheel
control
in "transmission
dis-
engaged"
position.
Pull freewheel
con-
trol out and into the slot and release
so
it is held in the disengaged
position,
The rear wheels
must lock and skid
when
you try to manually
push the tractor
forward.
If the rear wheels
rotate,
then the
brake
needs
to be serviced.
Contact
a
Sears
or other
qualified
service
center,
FRONT
WHEEL
TOE-raN/CAMBER
Your new tractor
front wheel
toe-in
and
camber
is set at the factory
and is normal,
The front wheel
toe-in
and camber
are
not adjustable.
If damage
has occurred
to
affect the factory
set front wheel
toe-in
or
camber,
contact
a Sears
or other
qualified
service
center,
TO REMOVE
WHEEL
FOR REPAIRS
1.
Block up axle securely,
2,
Remove
axle cover,
retaining
ring and
washers
to allow wheel
removat
(rear
wheels
have a square
key - Do not
lose).
3,
Repair
tire and reassemble,
Axle Cover
_---'. Square Key (Rear
Wheel Only)
TO START
ENGINE
WiTH
A WEAK
BAT-
TERY
_IWARNING:
Lead-acid
batteries
gen-
erate
explosive
gases.
Keep sparks,
flame
and smoking
materials
away from bat-
teries,
Always
wear
eye protection
when
around
batteries,
If your battery
is too weak
to start the
engine,
it should
be recharged.
(See "BAT-
TERY"
in the MAINTENANCE
section
of
this manual).
If "jumper
cables"
are used for emergency
starting,
follow
this procedure:
iMPORTANT:
Your tractor
is equipped
with a 12 volt system.
The other
vehicle
must also be a t2 volt system.
Do not use
your tractor
battery
to start other
vehicles.
TO ATTACH
JUMPER
CABLES
-
1.
Connect
one end of the RED cable
to the POSITIVE
(+) terminal
of each
battery(A-B),
taking
care not to short
against
tractor
chassis.
2.
Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal
(C) of
fully charged
battery.
3.
Connect
the other
end of the BLACK
cable
(D) to good chassis
ground,
away from fuel tank and battery.
TO REMOVE CABLES,
REVERSE
ORDER -
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both batteries.
25
