Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Tube assembly
To be able to turn on the product, it's necessary
to pull the tube (a) out of the body (b) as far as
the knob (d) pushed, support the whole tube;
to protect the tube, push it back into the body
as far as its projection touches the switch (c), as
shown in figure 2; the position of the tube
knob is shown in figure 3.
Note:
The tube shall be inserted into the body of the
equipment when not in use.
c
Figure 2
Figure 3
Attention!
Do not operate the equipment without
the tube.
Assembly Prior to Use
a
d
b
37
Debris bag assembly
Before fitting the debris bag, make sure the
blower/vacuum selector lever operates
smoothly, and that it is not obstructed by debris
from previous uses.
With your fingers, at the same time press the
buckle plate (e) on both sides of the debris bag
support. Fit the debris bag frame (f) on the
rectangular discharge tube, at the lower end of
the blower/vacuum, and insert the buckle plate
into the hole (g). Attach the debris bag as
shown in figure 5.
Attention!
Do not use the equipment in "blower" mode
without the debris bag.
f
Figure 4
Figure 5
ENGLISH
g
e
Tabla de contenido
