Kamikaze KVS7000P Manual página 42

Oil quantity
3
display
Electronic board
4 temperature
display
8.3. Error codes and descriptions
Displayed
Error description
code
E1 Chain rotation locking
E2 Hardware over-voltage
E3
E4 Incorrect voltage
E5
E6
E7 Overvoltage software
E8
E9 Low battery capacity
E13 Oil pump failure
E15 Overtemperature MOS
Note: if the problem is not clear, always contact with a service center.
°C
Circuit failure
Undervoltage
Overvoltage
Phase loss
1. Quantity oil settings:
press the button
before "HZ" (6) flashes and press the
button
necessary.
2. Flow rate settings:
press the button
Oil quantity
settings
"%" (5) flashes and press the button
to select the flow rate that is necessary.
3. Forced lubrication:
press the button
the forced lubrication and the icon
starts flashing. Press the button
seconds to stop the lubrication.
Non modifiable
Degrees
centigrade
Overextended chain or
motor/ reducer locking
Excessive force during
work or driver failure
Driver failure
Driver failure
The red-light
Low Battery
flashes
Battery failure
Activated protection
Motor failure or cable
Battery failure
Oil pump failure
Driver protection
until the number.
to select the oil quantity that is
until the nr before
for 3 seconds to start
Cause
Check chain tension or
contact service center
Adjust the force or
contact service center
Contact a service
Contact a service
Charge the battery
Substitute the battery
Automatic reset
Contact a service
failure
Substitute the battery
Contact a service
Automatic reset
for 3
Solution
center
center
center
center