Maintaining
the ice Bucket
+ To clean the ice bin/bucket, wash with a mild
detergent, rinse well, and dry thoroughly it,
Do not use harsh or abrasive cleaners or
solvents,
+
ice is made in cubes.
When you select "Crushed", the ice maker
grinds the ice cubes into crushed ice,
+ When you select Cubed ice after using the
Crushed ice mode, a small amount of residual
crushed ice might be produced.
+ The ice cubes generated by the rapid ice
making process will look white, which indicates
they are generated normally.
+
if you need a large amount of ice and the ice
maker is making ice cubes quickly, move ice
cubes from the refrigerator ice bin to the freezer
ice bin to open up space in the refrigerator ice
bin. The ice maker will then make additional ice,
+
if ice doesn't come out, pull out the ice bucket
and press the test button located on the right
side of ice maker, See the illustration below,
+
Do not press the test button continuously when
the tray is filled with ice or water,
Water may overflow or ice may jam the bucket,
Ice Making
To fill the ice bucket to maximum capacity after
installation, follow these steps:
1, Allow your refrigerator to operate and cool
down for 24 hours (or 1 full day).
Waiting 24 hours will allow your ice maker to
cool properly,
2, Dispense 4 to 6 ice cubes into a glass,
3, After 8, and then 16 hours, dispense a full glass
of ice,
+ When you press the Test button on the
icemaker, you will hear the refrigerator chime
(ding-dong),
When the chime sounds, release the Test
button,
+ The chime sounds automatically again to let
you know the ice maker is working well,
_C_eck
the water level
Z_ CAUTION
+
if you want to remove a large number of ice
cubes without removing the ice bucket, turn
off the ice maker, remove the ice maker's front
cover, and then carefully remove the ice cubes,
Replace the ice maker's front cover when you
are done. Note that the ice cubes in the ice
maker can spill out over the drawer,
+
Do not put food in the ice bucket, if you store
food in the ice bucket, the food can strike the
ice maker when you open or close the door,
causing damage to the ice maker,
+
Note that the ice cubes in the ice bucket may
spill out over the drawer when you remove the
ice bucket from the drawer.
if this occurs, be sure to pick up the ice cubes
that spilled out of the drawer,
+
if a power failure occurs, ice cubes may melt
then freeze together when the power comes
back on, causing the dispenser to stop
working,
To prevent this problem, after a power failure, pull
out the ice bucket and discard the residual ice or
water,
®
If you use all the ice at once, you must
repeat Steps 2 and 3 under ice Making,
However, only wait 8 hours before
dispensing the first 4 to 6 ice cubes.
This will replenish the ice cubes and
ensure maximum ice production,
Engl sh --25