cecotec CONGA ROCKSTAR 1500 RAY ERGOWET ANIMAL Manual De Instrucciones página 50

ENGLISH
Fig. 5 key:
1. Head release button
2. Trigger
Installing the wall bracket
Fig. 7
1. Place the wall bracket on the wall and mark the points where the holes are to be drilled
to fix the bracket. It is important that the vacuum head rests on the floor so that the wall
bracket does not support the full weight of the vacuum cleaner.
2. Drill the 3 holes (previously marked) and insert the plugs and screws.
3. Make sure that the charging base is securely fixed to the wall and place the vacuum cleaner
on the bracket, inserting the charging terminals of the vacuum cleaner into the charging
terminals of the bracket (plastic tab).
4. Once the wall bracket is installed, connect the power adapter to the charging port: you
will then be able to charge the vacuum cleaner by simply sliding it up and down the wall
bracket.
Charge and display
The battery must be charged with the wall bracket while it is connected to the main body.
-
Plug one end of the adapter into the power supply and connect the other end to the bracket.
During charge, the battery indicator will flash. When charging is complete, the battery
-
indicator will remain steady.
You can also charge the battery without using the wall bracket. You can charge the battery
-
when the battery is installed or not in the vacuum cleaner. Connect the adapter, then
connect the other end of the cable to the battery paying attention to connection direction.
Once properly connected, the battery indicator will flash and change to steady when
charging is complete.
5. CLEANING AND MAINTENANCE
Turn the appliance off, unplug it from the power socket, and allow it to cool down before
-
cleaning it.
Use a soft, slightly dampened cloth to clean the surface of the appliance.
-
Never immerse the appliance in water or other liquids. Do not allow liquids to enter the
-
appliance.
Do not use abrasive cleaners or scouring pads to clean the appliance.
-
Do not leave the vacuum cleaner in a place with direct sunlight.
-
Do not leave the vacuum cleaner in a wet place after cleaning it.
-
After the brush has been used for a long time, bristles might start to tangle with hair and
-
other dirt. Clean the brush to ensure cleaning efficiency.
- .
50