GE Profile 405 Manual Del Propietário página 8

Aboutyour dryerfeatures.
i iiiiii iiii ii ii ii,i iiiii ii,i,iiii ,111
Color Logic
Select the correct FABRICCAREsetting. Match
the particular color below the words with the
same color on the Cycle Dial.
[_] Choose the FABRICCAREsetdng--for this
load it would be the EASY CAREMED.
HEAT(which is a particular color).
Example:Drying a loadof clothing labeled
permanent press,
[]Turn the Cycle Dial to the area that has
the same color as the FABRIC CAREsetfing
you have chosen-for this toad it would be
the EASYCARE AUTOMATtC.
WRINKLE CARE
EXI_DEDCOOL AIF[ TUMBLE
SIGNAL
ELECT1_NIC TO_E
(appearance may vary)
i i ili
Dry.ess
;:: sensor Cycle
Wrinkle Care
Use this option to minimize the wrinkles
in clothes. It pro_'ides approximately 15
minutes of no-heat tumbling after the
clothes are dry,
This option can only be used with the
COTTONS, EASYCARE, D EUCATES, and
ULTRACAREcyctes, IIyou are using the CYCLE
SIGNAL and you select the WRINKLE CARE
option, a signal MII sound at the end of the
drying time and several times during the
WRINKLE CARE cycle,,This will remind you
that it is time to remove the clothes,
If WRINKLECAREis not ON,the dryer will stop
once the timer reaches the WRINKLE CARE
mark on the cycle dial
End of Cycle Signal
This signal Mll sound just before the end
of the cycle to remand you to remove the
clothes. On some models, the signal sound
level can be adjusted.
If you selected
the WRINKLECAREoption
the signal will sound at the end of the
drying time and will sound several times
during the WRINKLECARECYcle. T his will
remind you that it is time to remove the
c!othes_
NOTE."
[] Removegarmentspromptlyat the sound
of the signal Place clotheson hangers
so wrinkles won't set in.
[] Use the END OF CYCLE SIGNALespecially
when dryingfabrics like polyester knits
andpermanentpress. Thesefabrics should
be removedso wrinkles won't set in.
Dryness Sensor Cycle-on some models
This feature is only activated in the
COTTONS, E ASYCARE, D EUCATES, and
ULTRACARE CYcl e so
The DrynessSensorprovides greater
drying accuracy than standard machines,
resulting in shorter dry times and better
clothes care. As the clothes tumble, they
touch a moisture sensor. The sensorMtl
stop the heating cycle as soon as the clothes
have reached the selected dryness.
On some models, there is a Dryness
Sensor Cycleindicator light. This light is
illuminated during automatic cycles.
When the Dryness Sensor feature stops the
heating cycle, the light will go out and the
cool down period will begin.
Note:The clothes will be hot if they are
removed immediately after the indicator
light goes out.
Drum Lamp
Before replacing the tight bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching offthe
circafit breaker. Reach above dryer opening
from inside the drum. Remove the bulb and
replace with the same size bulb.
Automatic Cycle Signal-on some models
At the end of each cycle there is
approximately 15 minutes of no-heat
tumbling after the laundry is dry_
A reminder signa! _ sound periodically
during tl-fis0a-heto remind you to remove the
laundry,,
8