Idiomas disponibles
Idiomas disponibles
settings depending on which button you pressed.
Wireless (X connection): Xinput. Press the connection button (21)
+ X.
LED 1 and LED 4 will start flashing.
From the Bluetooth settings, you can now connect to this controller.
Wireless (Y connection): Press the connection button (21) + Y.
LED 2 and LED 3 will start flashing.
From the Bluetooth settings, you can now connect to this controller.
Wired (Windows only): Connect controller to a device with a USB
cable.
Note: If you only connect with USB, it will identify as an XBOX 360
controller.
LED 1 and LED 4 flashes.
Windows only: The controller defaults to XInput.
In XInput, "A" becomes "B", "B" becomes "A", "X" becomes "Y" and "Y"
becomes "X".
Switch Pro Controller mode is required for the 3.5 mm audio input
to work.
To make the Windows and Steam identify the controller as a Switch
Pro Controller, press the right stick (11), like a button and keep
it pressed.
Then connect the controller with a USB cable.
Compatible with windows 10/11 or higher.
STEAM wireless (Windows only)
Press and hold the connection button (21) for about 4 seconds to
connect.
The 4 LED lights will flash quickly (release the button).
From your PC's Bluetooth settings choose this controller.
LED 1 stays lit, indicating a successful connection.
Turbo
Turbo works on these buttons: A B X Y L R ZR ZL
1. Activate turbo: Press turbo button + button that you want
turbo on.
2. Activate automatic turbo: Press turbo button + the button that
already has activated turbo.
3. Turn off turbo: Press turbo + on the button that has automatic
turbo activated.
To turn off all turbo functions at the same time. Press and
hold the turbo button for about 6 seconds until the controller
vibrates.
Switch console: Test turbo settings -> Press the "Home"- button
from main screen -> System settings -> Controllers and sensors ->
Test Input Devices -> Test Controller Buttons.
Sleep mode
1. When the console's screen powers off, the controller will enter
sleep mode.
2. While connected, the controller will automatically enter sleep
mode after 5 minutes of inactivity.
Charging
To charge: Connect a USB cable to the controller and to a USB
power supply. For example, a USB power adapter or a computer.
The LEDs flash when charging. They flash differently depending
on status.
When fully charged, the LEDs will stay lit (connected). The LEDs
will turn off in sleep status.
While charging with a computer, you can't turn off the controller,
but you can turn off the LED's. See LED modes.
You can check battery level by making a quick press on – button +
turbo button.
LED indicators flashing quickly indicates low battery.
LED modes
Please note that the controller does not remember the last used
LED mode.
L + R
Turn the ABXY buttons' LEDs on or off by pressing and holding L + R
for 6 seconds.
ZL + ZR
Turn the right and left sticks' LEDs on or off by pressing and
holding ZL + ZR for 6 seconds.
+
OR
+
Increase brightness by holding the – button and press up on the
direction pad (13), or decrease by pressing down.
+
Change LED mode by holding the + button and press left on the
direction pad (13).
Modes: rainbow + breathing > rainbow + colour cycle > breathing >
static colour > off. Then it repeats.
12
