Craftsman 919.167342 Manual De Instrucciones página 10

Contents of Carton
1 - Air Compressor
1- Handle
1 - Grip Handle
4 - Self Tapping Screw
2- Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
1 - Rubber Strip
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
Unpacking
1. Remove unit from carton and
discard all packaging. NOTE:
Save all parts bags.
Assemble Handle
1. To make installation easier,
submerge handle grip into warm
soapy water. Remove handle
grip from soapy water and slide
onto handle.
2. Insert the handie inside the
compressor saddle and Iine up
the two bolt holes on each side.
3. Install the four screws, two on
each side.
4. Tighten securely.
Assemble Wheels
It win be necessary
to brace or
support one side of the unit when
installing the wheems because the
compressor will have a tendency
to tip.
1. Attach wheels with shoulder
bolts and nuts as shown.
2. Tighten securely. NOTE: The
unit wilI sit level if the wheels are
properly installed.
The wheels and
handle do not
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be mifted, or pushed
up a ramp.
Assemble Rubber Strip
1. Ctean and dry underside of air
tank leg opposite wheeIs.
2. Remove the protective paper
strip from the adhesive backed
rubber foot strip.
Handle
Grip
3. Attach the rubber foot strip to
the bottom of leg. Press firmly
into place.
Shoulder
WheeR Bo(t
Rubber Strip
A09708 10-ENG