Idiomas disponibles
Idiomas disponibles
15 Maintenance & Cleaning
Tools to be repaired must be sent to Customer Assistance Service. Use original part keeps the
tool good condition and safe.
isconnect the battery from the tool before checking, maintain and repair the pruning shear,
D
to avoid risk of unexpected actuating of the tool.
Please wear glove before you check the blade sharp or not, that's avoid blade hurt you. Check
the pruning shear frequently, this will keep tool safe and reliable.
•
Don't flush the tools or put it in water, it will cause short circuit or damage the device.
•
Keep ventilation, electric motor and handle cleaning, always use feather clean the device. Don't
use cleanser flush device, it will rust parts.
•
Clean the blade after every use, protect by oil or spray protection.
15.1 Sharpening
•
Sharpening is very important to keep blade in good condition and ensure long life.
•
The tool is supplied with an accessory to maintain the cleanliness and good condition of the blade
edge, but periodically you should consult a professional or technical service when you observe
deterioration of it.
•
Of course, the frequency of sharpening depends on the nature of the sheared wood (hardness
and diameter), pruning rate and sharpening tools (special abrasive tools are provided). As a result,
the blade must be checked frequently during the initial period of use to determine the
appropriate grinding time (check every 15 minutes and you will quickly calculate the frequency).
15.2 Lubricate of the blades
Lubricate the blades quickly every working day using the lubricating pin located in the central screw. To
guarantee the correct operation of the tool and to avoid friction between them, lubricate more deeply
every week as follows:
• Open the blades of the pruner.
• Switch off the tool and disconnect the battery.
• Apply the grease between the moving blade and the fix blade (see the picture below).
• Insert the battery on the pruner.
• Turn on the tool and pull the trigger sometimes to get the grease through the blades.
• Clean the blades from the grease leftover.
31
