cecotec CONGA ROCKSTAR 6500 CENTURY ERGOWET Manual De Instrucciones página 52

ENGLISH
- Use a soft, slightly dampened cloth to clean the surface of the appliance.
- Never immerse the device in water or other liquids, do not allow liquids to enter the
device.
- Do not use abrasive cleaners or scouring pads to clean the device.
- Do not leave the device in a place with direct sunlight.
- Do not leave the device in a wet place after cleaning it.
Emptying the dust tank. Fig. 9
- Place the dust tank from the main body over a bin.
- Push the black tab located on the lower part of the dust tank until the cover opens.
- Then, dust will fall off, so you must secure the tank is in the bin position.
Filter cleaning and maintenance. Fig. 10
- It is recommended to clean the filters regularly to ensure maximum efficiency.
- Pull the dust tank release trigger and separate the dust tank from the upright vacuum
cleaner.
- Remove the primary filter and the pre-filter assembly.
- Disassemble the pre-filter assembly by turning the mesh filter clockwise and pulling.
- Vacuum and shake the filters to remove every particle and dust remain that may block it
and make air circulation difficult.. Remember not to use the vacuum cleaner without the
filters properly assembled.
- Do not brush the filters.
Cleaning the brushes
It is important to clean the brushes regularly to avoid hair and other foreign objects from
tangling and to prevent blockages. Fig. 11
Fig. 12
- Press the brush release button on the bottom part of the brush head and remove the
brush.
- Remove the brush side tab.
- Remove the Jalisco brush from the vacuum cleaner brush head.
- In order to avoid any damages in the brush, hair can be cut and removed if it is wrapped
around both sides of the Jalisco brush.
- You can clean the Jalisco brush with warm water, do not use soap or detergents.
However, it is recommended to shake it or vacuum it to avoid placing it back again wet in
the brush head.
- If you decide to wash the Jalisco brush, make sure it is completely dry before installing it
again on the device.
- Make sure it is properly installed, otherwise the brush will not start operating.
52