CASO DESIGN WineComfort 66 black Manual Del Usuario página 31

12.5.3 The handle installing
The wine cooler comes with one metal
stainless steel handle. To install simply screw
them to the door with the supplied screws.
To do this, slide the rubber seal on the back of
the door to the side to lay open the predrilled
holes. Use the included screws to install the
handle on the door.
Then reinsert the rubber seal in the correct
position.
12.5.4 Wooden shelves
Usual shelf
12.5.5 To remove a shelf
Remove all bottles from the shelves.
Removal of the fixed shelves:
Carefully pull out the shelf until this is no longer possible.
Look at the shelf rail from the side.
You see a lever. There are 2 positions
1 = below - release with pressure at point A upwards
2 = up - release with pressure at point A down
Reach into the rail with one finger and change the position of the lever by pressing the lever.
Hold this new position of the lever appropriately on both sides of the shelf and then pull out
the shelf.
Lower shelf
31