Idiomas disponibles
Idiomas disponibles
Installing the Batteries in the Remote Control
Install the batteries (AAx2) matching the polarity
indicated inside battery compartment of the remote
control.
1
Open the cover.
2
Insert batteries.
Make sure to match + and - on the batteries to the
marks indicated in the battery compartment.
3
Close the cover.
Note
Incorrect use of batteries can result in hazards such as
leakage and bursting. Please observe the following:
•
Do not mix new and old batteries together.
•
Do not use different kinds of batteries together.
Although they may look similar, different batteries
may have different voltages.
•
Make sure that the + and - ends of each battery
match the indications in the battery compartment.
•
Remove batteries from battery compartment that is
not going to be used for a month or more.
•
When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction's rules that apply in your country or area.
•
Do not recharge, short-circuit, heat, burn or
disassemble batteries.
10
FUNCTIONAL OVERVIEW
Using a Remote Control
Keep in mind the following when using the remote
control:
•
Make sure that there are no obstacles between the
remote control and the infrared sensor window on the
unit.
•
Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the infrared
sensor window of the unit.
•
Remote control for different devices can interfere with
each other. Avoid using remote control for other device
located close to the unit.
•
Replace the batteries when you notice a fall off in the
operating range of the remote control.
•
The maximum operable ranges from the unit are as
follows.
-
Line of sight: approx. 23 feet (7m)
-
Either side of the center: approx. 16 feet (5m) within 30°
-
Above: approx. 16 feet (5m) within 15°
-
Below: approx. 10 feet (3m) within 30°
16 feet
(5m)
30˚
30˚
23 feet
16 feet
(7m)
(5m)
EN
