Idiomas disponibles
Idiomas disponibles
TO REPLACE FRICTION WHEEL
If the snow thrower wil! not move forward,
and the friction wheel is worn or damaged,
you need to replace it as follows: (First allow
the engine to cool).
o Drain the gasoline from the fuel tank by
removing the fuel line at the carburetor.
Drain the fuel in a container and reipstall
the fuel line.
CAUTION:
Drain gasoline outdoor
away from fire or flame.
° Disconnect the spark plug wire,
° Stand the snow thrower up on the auger
housing end°
° Remove the bottom panel (see second
figure on page 21).
° Remove the three (3) fasteners securing
the friction wheel to the hub (see figure
below).
Friction Wheel',,_!'-'_I
r{[_=
Lockwasher
Bol
i_,=!
Shaft
Bo_
u
"_ Lockwasher
• Remove the four bolts securing the bear-
ing plates (both sides), (see second fig-
ure on this page)_
• Remove right side bearing plate, Leave
hex shaft in original position.
° Remove friction wheel from hub. Slip fric-
tion wheel off hex shaft towards right
side.
° Slip new friction wheel onto hub with re-
cessed or cupped end away from hub
(see figure above).
, Install bearing plates to original position.
Ensure
hex shaft is engaged
with both
bearing ptates_
° Secure bearing plates;
using bolts re-
moved earlier.
Secure friction wheel to hub using fasten-
ers removed earlier. Ensure hex shaft
turns freely.
Bearin
Plate
Friclion
Bearing
Plate Bolts
Fasteners
(Bolts,
and nuts),/ .....
/
/
Auger
..........................................
iJ
._._e
e
e
e
e
NOTE: Ensure friction wheel and friction
disc are free from grease or oil.
• Replace bottom panel
° Lower the snow thrower onto the tires.
TO REPLACE
AUGER
SHEAR
BOLT
The augers are secured to the auger shaft
with special bolts (see figure below) that are
designed to break (to protect the machine)
if an object becomes lodged in the auger
housing. Use of a harder bolt will destroy the
protection provided by the shear bolt.
IMPORTANT: To ensure safety and perfor-
mance levels,only original equipment shear
bolts shouldbe used. When replacing shear
bolts, be sureto replace shear bolt spacers.
Shear Bolt._
Shear Bolt
° To replace a broken shear bolt, proceed
as follows:
, Move the throttle to I_1 (STOP) and turn
off all controls.
, Disconnect the spark plug wire° Be sure
all moving parts have stopped.
• Lubricate the auger shaft zerk fitting (See
the Maintenance
section on pages 15-
17)+
22
