Idiomas disponibles
Idiomas disponibles
19o Neveroperatethe snowthrower
withoutgood visibilityor lighLAlways
be sureof your footing,andkeepa
firm hold on the handles_ Walk;never
run.
MAINTENANCE
AND
STORAGE
1.
Check shear bolts and other bolts
frequently
for proper tightness
to be
sure the snow thrower is in safe
,
working
condition.
2.
Never store the snow thrower
with fuel
in the fuel tank inside a building
where
ignition
sources
are present
such as
hot water and space heaters,
clothes
dryers,
and the like. Allow the engine
to cool before
storing in any enclosure.
3.
Always
refer to operator's
manual
instructions
for important
details if the
snow thrower
is to be stored for an
extended
period.
4.
Maintain
or replace
safety and
instruction labels, as necessary.
5.
Run the snow thrower
a few minutes
after throwing
snow to prevent freeze-
up of the augedimpeller.
,_
WARNING:
The engine exhaust
from this product
contains
chemicals
known to the State of California
to cause
cancer,
birth defects
or other reproductive
harm.
Z_
WARNING:
This snow thrower
is for
use on sidewalks,
driveways
and other
ground
level surfaces.
Caution
should be exercised while using on
steep sloping
surfaces.
DO NOT USE
SNOW THROWER
ON SURFACES
ABOVE GROUND
LEVEl. such as roofs of
residences,
garages,
porches or other such
structures
or buildings.
Contents of Parts Bag
- Owner's Manual (not shown)
Parts Bags (not shown)
Non Assembly paris
• 2 - Spare Shear Bolts
114-20 x 1-314 In.
*2 - Spare 1/4 - 20 Locknuts
"2 - Spare Spacers
2.3t8-16 x 2 In. Hex Head Bolt
2 .318 In, Flatwashers
2 - 3/8 In. Lockwasher
2- 3/8 In. Hex Nut
1 -11/32 Inch
Flat washer
I - Starter Motor Cord
1 - Cotter Pin
,,,,,,,ii,,,,,,,,, ,,,.,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,, ,,,,,
>
1- Cable Tie
4
