Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
•
Mounting a grinding disc*
Use grinding discs of the correct dimension. Use fibre
reinforced grinding discs only. The grinding disc must
not touch the edge of the guard.
- Press the spindle lock and turn the spindle (8) until
it engages in the lock. Keep the spindle lock pressed
during this procedure.
- Remove the flange nut(7) from the spindle using the
spanner(6).
- Position the grinding disc(2) on the flange(9).
- Place the flange nut on the spindle an tighten it
using the spanner.
- Release the spindle lock and check that the spindle
is unlocked by rotating it.
*Depending on model
Mounting the side handle*
The side handle can be used for both lefl-hand and right-hand control.
- Fasten the side handle for left-hand operation on the right-hand side of the machine.
- Fasten the side handle for right-hand operation on the lefl-hand side of the machine.
- Fasten the side handle for upright working at the top pf the machine.
*Depending on model
CAUTION: Make sure that the side handle is fastened properly and can not loasen unexpectedly.
5. OPERATION
Always observe the safety instruction and applicable regulations.
CAUTION: Do not place the machine on the workpiece when switching the machine on or off. The
grinding disc may damage the workpiece.
- Clamp the workpiece and make sure that the workpiece can not slide from under the machine during
the cutting activities.
- Hold the machine firmly and press it under an angle of approximately 15" against the workpiece.
Move the grinding disc evenly across the workpiece.
- Regularly inspect the grinding disc. Worn grinding discs have a negative effect on the efficiency of the
machine . Replace a grinding disc on time.
- Always switch off the machine first befare removing the plug from the wall socket.
19
