Idiomas disponibles
Idiomas disponibles
12
Daily use
Select the spin speed, NIGHT CYCLE or RINSE HOLD option (button 3)
When the required programme has been selected, your appliance automatically proposes
the maximum spin speed provided for that programme.
Press this button repeatedly to change the spin speed, if you want your laundry to be spun
at a speed different from the one proposed by the washing machine.
RINSE HOLD: by selecting this option the water of the last rinse is not emptied out to pre-
vent the fabrics from creasing. At the end of the programme,
appear on the display, DOOR symbol (door locked) remains lit, the pilot light of button 7
goes off and the door is blocked to indicate that the water must be emptied out.
NIGHT CYCLE: by selecting this option, the machine will not drain the water of the last
rinse, so as not to wrinkle the laundry. As all spinning phases are suppressed, this washing
cycle is very noiseless and it can be selected at night or in times with a more economical
power rate. In some programmes the rinses will be performed with more water. At the end
of the programme,
mains lit, the pilot light of button 7 goes off and the door is blocked to indicate that the
water must be emptied out.
To empty out the water, please read chapter «At the end of the programme».
Programme option buttons
Depending on the programme, different functions can be combined.
WARNING!
Not all the options are compatible among themselves. The symbols of the incompatible op-
tions disappear.
Anyway, if an option, which is not compatible with the set washing programme or any oth-
er option, is selected, the Err message is displayed for few seconds and the yellow pilot of
button 7 light starts blinking.
You must select the options after you have selected the programme but before pressing the
button 7. Press the button 4: all the option symbols appear on the display.
To scroll all the available options, press the button 4. The corresponding symbol appears on
the display and starts blinking.
Press the button 5 to activate and confirm your choice. A black dash appears under the
selected symbol to indicate that this option has been set. Press the same button to deacti-
vate the option.
After selecting the options, wait about few seconds until the display gets back to the de-
fault status. The selected options appear on the display.
For the compatibility among the options and the washing programmes see chapter «Wash-
ing Programmes».
PREWASH option
Select this option if you wish your laundry to be prewashed at 30°C before the main wash.
The Prewash ends with a short spin in programmes for cotton and synthetic fabrics, where-
as in the programmes for delicate fabrics the water is only drained.
The relevant symbol will appear on the display.
and RINSE HOLD symbol appear on the display, the DOOR symbol re-
and RINSE HOLD symbol
