Bigben PARTY PARTYBTHPS2 Manual De Instrucciones página 14

Charging:
When you hear the low battery warning beep, you should switch off the speaker and recharge
it.
Connect the USB-C cable to the charging port on top of the speaker. During charging, the LED
indicator turns red. The charging LED light switches off when charging is complete.
A full charge can take 5 to 6 hours depending on the USB power source.
Bluetooth connection:
When the speaker is turned on, the speaker automatically switches to Bluetooth search mode.
Look for and select "PARTYBTHPS2" on your mobile device. Once found, a beep will sound
to indicate that the speaker is connected to the device.
Pairing function
You can only do this if there are two PARTYBTHPS2.
1. Switch on the two speakers and put them into Bluetooth mode.
2. Hold down the Play/Pause button on one of the speakers for 3 seconds. Release the
button when you hear a beep. Both speakers are now connected.
3. Then, switch on your phone's Bluetooth and look for PARTYBTHPS2, then pair with the
speaker and connect to play your music through it.
4. In pairing mode, press and hold the Play/Pause button to disconnect the pairing.
Device technical specifications
Audio power
Unit
Bluetooth version
EIRP
N.B.: The maximum connection distance is approximately 10 metres. Place your Bluetooth
speaker as close as possible to the device to avoid any interference with the connection.
The device may turn off in an environment with electrostatic discharge. The user must
then recharge the battery and reset the device.
10 W
3'' X1
5.3
0.9 dBm
- EN 14 -
Built-in battery
Frequency response
Dimensions
3.7 V 1,800 mAh
80Hz - 18 kHz
145 x 138 x 190 mm