Idiomas disponibles
Idiomas disponibles
User manual
MPPT
In order to get the maximum power from the panel when recharging an appliance, it is necessary to use an
MPPT
MPPT type solar controller connected between the solar output of the panel (1) and the battery.
PANEL IMPLEMENTATION
1. Fully extend the panel with the cells facing the sun.
2. If it is preferred or necessary to secure the product (e.g. in windy conditions), use the eyelets in each corner to hold
the panel in place and prevent it from being lost or damaged.
3. Connect the appropriate accessory and cable to the type of device you wish to charge.
• Walking, jumping or standing on a cell can cause micro-cracks that have a direct impact on the perfor-
mance, and the overall efficiency of the solar panel in general.
• Keep all contacts and connectors clean and dry.
RECHARGING YOUR DEVICES
8
Translation of the original
instructions
The ideal condition to reach the maximum power of the solar panel.
A sunny midday during the winter, with cloudless weather and a completely clear horizon.
Unregulated solar output
Connect your device to the socket:
1. Solar output (5.5mm jack)
For charging a battery:
2
It is necessary to use a solar controller that is connected between the panel
output (1) and the battery.
For charging another device:
3
Check whether the output of the solar panel (1) can be connected directly to
the charging input of the device, or whether the use of an intermediary solar
controller is necessary.
4
Auxiliary outputs
1
Connect the USB cable (not supplied) of the device you wish to charge to
one of the appropriate outlets listed below:
2. USB-A
3. USB-A (QC 3.0 - 20 W)
4. USB-C (PD - 18 W)
SOLAR PANEL 18 V - 100 W
