Idiomas disponibles
Idiomas disponibles
Your new tiller has been assembled
at the
factory with the exception
of those parts
left unassembled
for shipping
purposes.
To ensure safe and proper operation of
your tiller all parts and hardware you
assemble
must be tightened
securely.
Use the correct tools as necessary to
insure proper tightness.
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier.
Standard wrench sizes are listed.
(1) Utility knife
(1) Wire cutter
(1) Tire pressure gauge
(1) Screwdriver
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR'S
POSITION
When right or left hand is mentioned
in
this manual, it means when you are in the
operating
position
(standing
behind tiller
handles).
LEFT
FRONT
OPERATOR'S
POSITION
RIGHT
CONTENTS
OF HARDWARE
PACK
/IIIIIII/Y
(2) Handle
Locks
(1) Hairpin
Clips
(2) Shear Pins & Clips
(1) Carriage
Bolt
3/8-16 UNC x 1 Gr. 5
, (1) Flat Washer
13/32 x 1 x 11 Ga.
©
@
(1) Center
Locknut
3/8-16
UNC
(1) Cable Clip
(1) Pivot
Bolt
3/8-16
UNC Grade
5
(1) Handle Lock Lever
5
