Hayward RC34 Serie Manual Del Usuario página 37

● If the cleaner fails to pick up fine or heavy debris:
○ It may be clogged. Clean the filter. A filter cleaning solution can be purchased from your Hayward retail dealer to remove
excessive dirt and/or sand.
● If the cleaner starts working momentarily but then stops working:
○ Impeller may be clogged or jammed with debris, check and clean
if necessary following the instructions in the maintenance section.
○ Brush roller or drive tracks may be stuck, check for debris and clean
if necessary.
○ Cleaner performs by both timing and a pool wall detection sensor,
whichever comes first.
● There are 3 intake ports located at bottom of filter bucket and near the brush roller,check for debris and clean if necessary.
● Cleaner may get stuck if a high main drain is installed in the pool. Cleaner may remain lodged on the drain for a short
period of time, but will eventually free itself by virtue of the cleaner's embedded program.
● Cleaner performance: Confusion may exist over the perception of how the cleaner operates at different times during each
cycle. It is important to judge the performance of the cleaner by observing improved pool cleanliness after the cleaner has run a complete cleaning cycle.
● If a cleaner has poor coverage of the pool in one cycle or only covers a small area, check the filter and clean if necessary
and make sure the unit is not getting caught on drains, in-floor cleaning heads or toys. The user may try starting the
cleaner in different locations to find the optimum cleaning location.
● If debris falls from cleaner while removing from pool, it may be caused by filter overload, increase frequency of filter
cleaning. Assure that there is no large debris blocking any of the three intakes. Large debris must be removed from the
pool before using machine. If drain flaps are out of place or stuck by sand or leaves in the open position, the flaps can be
snapped back into place, after cleaning the area.
● If the flotation cord gets twisted which can be caused by the cleaner getting stuck on large objects such as rocks, toys or
main drains, it can be straightened by laying the flotation cord at full length (if possible)in the sun; heat from the sun will
help reduce the cord twisting.
● If a high level of debris is visible through the dome windows (if so equipped), remove cleaner quickly from the water to
reduce the chance of the debris escaping the filter bucket and reentering the pool.
HAYWARD only warranties the quality, performance and safety of its products when assembled with genuine
Hayward manufactured parts. Use of non-genuine Hayward manufactured parts will void all warranty.
Page 16 of 20
TROUBLESHOOTING - CLEANER
Rev. C