Weed Eater GHT 195 Manual De Instrucciones página 5

Idiomas disponibles

Idiomas disponibles

OPERATING
POSITION
3. Slowly press the primer bulb 6 times.
4. Move the choke lever to the FULL CHOKE
position.
Primer
Bulb
Choke
Lever
STOPPING
YOUR
ENGINE
• To stop the
engine,
move
the
ON/OFF
switch to the OFF position.
STARTING
YOUR
ENGINE
• Fuel engine.
Move at _east 10 feet (3 me-
ters) away from the fuefing site.
• Hold the unit on the ground
in the starting
position
as shown.
Support
unit
so the
blade
is off of the ground
and away from
trees, bushes, onlookers,
etc.
/
!-
i
STARTING A COLD ENGINE (or a
warm
engine
after
running
out of
fuel)
Throttle
Lock
._
Throttle t
Throttle
_-f___
-_"-_
Trigger
I_
/'_--_'T_-_
- __'_
"_--
_
-_
1. Move the ON/OFF
switeh
to the ON posi-
tion.
2. Engage the throttle
lock as follows:
• press the throttle lock-out;
• squeeze
and hold throttle trigger;
• press and hold throttle lock, then
• release
the throttle trigger
NOTE:
Keep the throttle
lock engaged
until
the engine starts.
ON
OFF
Switch
5. Pull starter
rope handle sharply
until en-
gine sounds
as if it is trying to run, but do
not pull rope more than 6 times.
6. Move
the
choke
lever
to
the
HALF
CHOKE
position.
7. Pull starter
rope sharply
until the engine
runs, but no more than 6 pulls.
NOTE:
If the engine doesn't start after 6 pulis
(at the HALF
CHOKE
position),
check
to
make sure the ON/OFF
switch
is in the ON
position.
Move the choke lever to the FULL
CHOKE
position and press the primer bulb 6
times;
pull the starter
rope 2 more
times.
Move the choke
lever to the HALF CHOKE
position and pull the starter rope until the en-
gine runs, but no more than 6 more pulls.
If
the engine
still doesn't
start,
it is probably
flooded.
Proceed to STARTING
A FLOODED
ENGINE.
8. Once the engine starts, allow the engine to
run 10 seconds, then move the choke iever
to the OFF CHOKE position. Allow the unit to
run for 30 more seconds at the OFF CHOKE
position before squeezing and releasing the
throttle trigger to release the throttle lock.
NOTE:
If engine dies with the choke lever in
the OFF CHOKE position,
move the choke le-
ver to the HALF CHOKE
position and pull the
rope until the engine runs, but no more than 6
pulis.
STARTING
A WARM
ENGINE
1. Move the ON/OFF
switch to the ON posi-
tion.
2. Slowly press the primer bulb 6 times.
3. Move
the
choke
lever
to
the
HALF
CHOKE
position.
4. Engage
the throttle
lock
as directed
in
STARTING
A COLD
ENGINE.
NOTE:
Keep the throttte
lock engaged
until
the engine starts.
5. Pull starter rope sharply until engine runs,
but no more than 5 pulls.
6. Altow the engine to run t0 seconds,
then
move the choke lever to the OFF CHOKE
position.
7. Release the throttte _ock by squeezing
and
releasing
the trigger.
NOTE:
If engine has not started, pull starter
rope 5 more pulls. If engine still does not run, it
is probably flooded.
Proceed to STARTING
A
FLOODED
ENGINE.
-5-
loading

Este manual también es adecuado para:

Ght 225