Idiomas disponibles
Idiomas disponibles
Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Pull off the canopy bottom cover (JJ) from the canopy
□
Loosen the two canopy screws (HH) located on the bottom of the
mounting bracket (A), and turn the canopy counterclockwise
to remove the mounting bracket (A) from the canopy (C).
II
3
Assembling the fan
NOTE: This fan is equipped with a safety tab. Should the
setscrew (LL) ever become loose while the fan is running
in reverse, the safety tab will engage and stop the fan from
falling.
□
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly (E).
□
Carefully insert the hanger pin (DD) through the holes in the
collar and ball/downrod assembly (B). Be careful not to jam
the hanger pin (DD) against the wiring inside the ball/downrod
assembly (B).
□
Insert the locking pin (EE) through the hole near the end of the
hanger pin (DD) until it snaps into its locked position.
□
Re-tighten the setscrews (LL) on the collar on top of the
fanmotor assembly (E).
2
□
□
□
A
C
JJ
7
Routing the wires
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (JJ).
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
PP
DD
Please contact 1-855-HD-HAMPTONBAY for further assistance.
C
JJ
B
D
E
C
JJ
B
D
EE
LL
E
HAMPTONBAY.COM
