Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan( continued)
Install remote control
1.Remove the mounting bracket from the canopy by loosening the
two canopy screws located in the L-shaped slots.
2.Remove and save the two canopy screws in the round holes.
This will enable you to remove the mounting bracket.
3.Carefully push the canopy to the bottom of the mounting bracket,
make two sliding holes aligned to the two prominent screws on the
mounting bracket, and then turn clockwise until tight.
4.Push the canopy ring to the bottom of the canopy,slide the inner
holes aligned to the two prominent screws on the mounting bracket
again, and turn the canopy ring clockwise until tight.
Prepare for mounting
10
Assembly - Attaching the Fan Blades
WARNING: Remove the rubber motor stops on the bottom of the
fan before installing the blades or testing the motor.
NOTE: Your fan blades are reversible.Select the blade side finish
which best accentuates your decor.
NOTE: Your fan features revolutionary advancements for quick and
easy blade installation.Including an alignment post and captive
blade arm screws.
Attaching the blades to the arms
1:Pass the red washer through the screw.
2:Tighten the screw through the blade and tighten it on the arms.
3:Repeat the above steps to tighten the four sets of blades.
Assembly - Attaching the Lights
Install the crystal shade & bulb
Phillips
screwdriver
1.After removing the
bottom decoration of the
lampshade,get the parts
and prepare for the next
step of installatior
11
EN
