Makita RT0700C Manual De Instrucciones página 5

adjusted to suit the material and bit diameter.
Refer to the table for the relationship between the num-
ber settings on the dial and the approximate tool speed.
Number
1
2
3
4
5
6
CAUTION:
• If the tool is operated continuously at low
speeds for a long time, the motor will get over-
loaded, resulting in tool malfunction.
• The speed adjusting dial can be turned only as
far as 6 and back to 1. Do not force it past 6 or
1, or the speed adjusting function may no longer
work.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing trimmer bit
1
3
► 1. Tighten 2. Loosen 3. Hold
min
-1
10,000
12,000
17,000
22,000
27,000
30,000
2
5 ENGLISH
1
► 1. Tighten 2. Loosen 3. Shaft lock
CAUTION:
• Do not tighten the collet nut without inserting a
bit, or the collet cone will break.
• Use only the wrenches provided with the tool.
Insert the bit all the way into the collet cone and tighten
the collet nut securely with the two wrenches or by
pressing the shaft lock and using the provided wrench.
To remove the bit, follow the installation procedure in reverse.
OPERATION
For the trimmer base
Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Move the tool forward
over the workpiece surface, keeping the tool base flush
and advancing smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
4
1
2
3
► 1. Workpiece 2. Bit revolving direction 3. View from
the top of the tool 4. Feed direction
CAUTION:
• Since excessive cutting may cause overload
of the motor or difficulty in controlling the tool,
the depth of cut should not be more than 3 mm
(1/8") at a pass when cutting grooves. When
you wish to cut grooves more than 3 mm (1/8")
deep, make several passes with progressively
deeper bit settings.
3
2
2
4